How to attach a Tempmaster Pro to a Bullet smoker

Hi, I'm Rhiannon from Flaming Coals and today I'm going to demonstrate how the Flaming Coals Temp Master Pro attaches to a Bullet Smoker. For the purpose of today's demonstration will be installing the Flaming Coals Temp Master Pro on a Pro-q Smoker. 

The Temp Master Pro will attach to any bullet smoker that has a removable air vent on it. 

The first step is to remove the air vent by undoing the screw on the inside of the smoker

The next step is to attach the Universal Adapter to the Bullet Smoker. On the back of the adapter just remove the screw.

Attach the Universal Adapter over the position where the vent was and insert the screw through the hole. 

Once you've attached the Universal Adapter to the side of your Bullet Smoker the next step is to attach the fan. Simply line it up and screw it in a clockwise direction.

The next step to attaching your Temp Master pro onto a bullet smoker is to simply plug the fan into the side of the temperature controller.

The Flaming Coals Temp Master Pro comes with a high-quality Sennheiser temperature probe. Simply plug it into the side of the fan controller and then insert this into your Bullet Smoker. You can either insert it through the top vent of the smoker or simply lift the lid and then clip it onto the grill. 

The last step is to plug the transformer into the fan controller. Plug it into a standard 240-volt power point and simply turn it on.

Finally, you can set the temperature of your fan controller to moderate the temperature inside your bullet smoker and that is how you install a Flaming Coals Temp Master Pro to a Bullet Smoker

Check Our Smoker Accessories

by: Rhiannon Peterson